How do I clean a clogged impeller on my Liberty?

Caution: This robot is battery-powered. Follow the instructions for your version exactly, in the order shown.

Without an impeller Cleaning Safety Clip

Start with your Dolphin Liberty out of the pool and switched off.

1. Switch your Dolphin Liberty on.
2. Let 3 seconds pass, then switch it off.
3. Wait 30 seconds. Before continuing, confirm that all LEDs are off and none is blinking.
4. Lift the Liberty's top cover and take out the filter basket.
5. Check the impeller for visible debris and remove any you can see.

With an impeller Cleaning Safety Clip

Start with your Dolphin Liberty out of the pool and switched off.

1. Attach the charger to the robot.
2. Do not continue until the blue LED has stopped blinking.
3. Wait 30 seconds. Before continuing, confirm that all LEDs are off and none is blinking.
4. Lift the Liberty's top cover and take out the filter basket. Leave the charger connected throughout cleaning.
5. Make sure the top cover is open and the filter basket is removed.
6. Put the impeller Cleaning Safety Clip in place.
7. If you cannot reach the debris, use a screwdriver to unscrew the screws on the top cover.
8. Slide the impeller cover backward to free it.
9. Remove debris caught around the impeller. Be careful: the impeller blades are sharp.
10. Refit the impeller cover, then take out the impeller Cleaning Safety Clip.
11. Put the filter back and shut the lid.

For other robots, use the appropriate guide below.

Our general Dolphin impeller cleaning steps

EON robot impeller cleaning steps