How do I use the Clicker with my cordless robot?

The Clicker retrieves Dolphin Liberty 300/400/600 after a cleaning cycle ends. Liberty 600 and EON™ 100/120d also have Click-to-Stop, which lets you stop cleaning before the cycle finishes.

Retrieve your robot after cleaning

1. Once cleaning finishes, the robot waits at the preferred Homing wall you selected in the Maytronics One app. If you have not set a Homing wall, it waits at a wall selected at the start of the cycle.
2. To call the robot up the wall, shake the Clicker in the water for at least 3 to 5 seconds.
3. Pick up the robot during its wait on the wall, which lasts about one minute. If you do not remove it, the robot goes back down and waits at another wall.

Stop cleaning mid-cycle, Liberty 600 and EON™ 100/120d

1. With the robot on the pool floor and not climbing, shake the Clicker for 3–5 seconds to stop cleaning.
2. Shake the Clicker a second time to send the robot toward the Homing wall. This requires the Homing feature to be calibrated.

Important: The robot cannot respond to the Clicker during an active climb. Homing is unavailable if Beach Entry is turned on in the app.

Use the Clicker in Eco Mode/UltraRun™ Mode

Using the Clicker during Eco/UltraRun™ Mode cancels all scheduled cycles that remain. Before putting the robot back in the pool, restart Eco/UltraRun™ Mode.

The robot can detect the Clicker for 14 days during Eco/UltraRun™ Mode. If Eco/UltraRun™ Mode begins with a full battery, the Clicker stays available for at least 2 days after the 2-week Eco/UltraRun™ Mode ends, when applicable.