How do I set Eco Mode on my Liberty 600?

You can set Eco Mode on your Dolphin Liberty 600 using the robot's controls or the MaytronicsOne App.

Set Eco Mode on the robot

1. Step 1: Use the Mode Selector button. Push the Mode Selector button (•••). An LED beside the selected mode will turn on.
2. Step 2: Check the default mode. The robot starts in Regular Mode. This setting cleans the floor, walls, and waterline in three 60-minute sessions every 72 hours.
3. Step 3: Select Eco Mode. Keep pressing the button to switch to Floor Only or Eco Mode. Eco Mode provides three 1-hour cleaning cycles, with 48-hour intervals between cycles.

Use the app to configure additional cleaning modes, including the 2-week Eco Mode.

Set Eco Mode in the MaytronicsOne App

1. Step 1: Open the app. Launch the MaytronicsOne App and check that the robot is not charging.
2. Step 2: Choose Eco. Select the arrow beside the cleaning mode, then select 'Eco' from the list.
3. Step 3: Choose a schedule. In the Eco tab, select your preferred cycle configuration:
   • Half-week: 2 sessions of 90 minutes each, every 72 hours.
   • One week: 3 sessions of 60 minutes each, every 72 hours. This is the default setting.
   • Two weeks: 6 sessions of 40 minutes each, every 48 hours.

Homing and Clicker behavior

With Homing enabled, the robot waits at your selected wall after each cleaning cycle ends.

Using the Clicker while in Eco Mode cancels the upcoming scheduled cleaning cycles.